[mrtg] Re: Compaq/Microcom 4000

[Jacek Zabicki]

Could you tell me where do you configure SNMP on T1/PRI card. I can telnet
to it but configuration program (cfgcurr) does not mention SNMP.

-----Original Message-----
From: mrtg-bounce at list.ee.ethz.ch [mailto:mrtg-bounce at list.ee.ethz.ch]On
Behalf Of Eric Krichbaum
Sent: 20 September, 1999 12:34
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] Re: Compaq/Microcom 4000


It does if you are running a PRI.  I can get data from it but the channels
up/down don't make sense and none of the numbers make sense.

Eric

At 12:21 PM 9/20/99 -0400, you wrote:
>I was told by Compaq support that Microcom 4000 does not have SNMP support.
>
>-----Original Message-----
>From: mrtg-bounce at list.ee.ethz.ch [mailto:mrtg-bounce at list.ee.ethz.ch]On
>Behalf Of Eric Krichbaum
>Sent: 20 September, 1999 11:25
>To: mrtg at list.ee.ethz.ch
>Subject: [mrtg] Compaq/Microcom 4000
>
>
>Has anyone successfully monitored the Compaq Microcom 4000 (Microcom
>ISPORTE)?  I got something from the D channels but it doesn't make any
>sense.  I'd like to monitor the modems and the totals.
>
>Eric

--
* To unsubscribe from the mrtg mailing list, send a message with the
  subject: unsubscribe to mrtg-request at list.ee.ethz.ch
* The mailing list archive is at http://www.ee.ethz.ch/~slist/mrtg