[mrtg] Re: MRTG with Cisco 2900 series switch

[Mitchell, Warrick (CSC at Alcoa)]

Hi Jerry,

If you run cfgmaker without any arguments, it will display it's help, in the
help it has the following options to solve your problem:

  --no-down         do not look at admin or opr status of interfaces

  --show-op-down    show interfaces which are operatively down

i.e. cfgmaker --show-op-down public at my.router.com

Which will produce a config file which has all ports that are not
administratively set to shutdown shown.

If you want all ports regardless of their state, i.e. up, down,
administratively down, use the --no-down option.

Kind regards,
Warrick Mitchell
Network Engineer

ALCOA World Alumina of Australia
* Phone:  9316 5160  Fax:  9316 5228
* E-mail:  <mailto:Warrick.Mitchell at alcoa.com.au>


-----Original Message-----
From: Jerry Hsieh [mailto:jerry at intervideo.com]
Sent: Wednesday, January 15, 2003 09:15 
To: mrtg
Subject: [mrtg] MRTG with Cisco 2900 series switch



Hi all,

I am trying to use MRTG to monitor traffic on Cisco 2900 switches. When I
run cfgmaker, the cfg file will comment out the ports are not activate(no
system connected). Is there any way to enable this? Thanks for your time.

Regards,

Jerry Hsieh

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi