[mrtg] riverstone

[Nicolás Quesada]

thanks a lot. so clear. i'll follow these steps.

only one more question: can i change the SNMP version value in GETIF?
i cannot find where

thanks a lot!

On 8/26/09, Steve Shipway <s.shipway at auckland.ac.nz> wrote:
> It looks to me very much that you have either (1) the wrong SNMP community,
> or, more likely, (2) the device ACLs are not set as you think they are.
>
> Since even getif and snmpwalk don't work, its not a MRTG or cfgmaker issue.
>
> Since someone else is doing this successfully, the device clearly supports
> SNMP.
>
> Check the following -
> 1. The device has SNMP enabled, but maybe it only have SNMPv2 enabled?  Try
> doing a walk with SNMPv2c rather than SNMPv1
> 2. Check the ACLs - maybe that community is only enabled for certain IP
> addresses?
> 3. Find the person who has working SNMP - get them to take a look at your
> config :).  Ask them which SNMP version they are using, who set up the
> router, etc.
> 4. Possibly there is a firewall between you and this router that is blocking
> SNMP?
>
> Steve
>
>