[mrtg] Re: MRTG and VLANS

[Phillip Ryker]

Alex,

So my syntax should look like this:

	public at 2<ip address>

So if the switches IP was 10.10.10.10 would it need to look like this:

	public at 210.10.10.10

I am a little confused here... :-)

Alex van den Bogaerdt wrote:
> 
> > I am running MRTG on a cisco Catalyst 2924XL switch.  The switch has
> > been VLAN'ed into 3. Ports 1-8 on VLAN1, ports 9-16 on VLAN2 and ports
> > 17-24 on VLAN3. For some reason MRTG only runs on the ports in VLAN1. It
> > shows zero traffic going through all the other ports that are in VLAN's
> > 2 and 3.
> >
> > Any ideas on what the proper info is to have it run stats on the 2nd and
> > 3rd VLANS??
> >
> 
> Not that I have any experience with this switch but I know that
> to access the _bridge_ OIDs on an catalyst 5500 you could use the
> community string appended with @2 and @3.
> Perhaps something similar will do for you.
> 
> Thus, if your community string is "public":
> snmpwalk switch public at 3 .....
> 
> HTH
> Alex

-- 
--------------------------------------------------------------------
Phillip Ryker					pryker at skynetweb.com
President					SkyNetWEB Ltd
Phone: 410-563-6384 Ext 12			1301 S. Baylis St.
Fax: 410-563-5457				Baltimore Md. 21224
--------------------------------------------------------------------
Dedicated servers, co-location and web hosting services...
--------------------------------------------------------------------

--
* To unsubscribe from the mrtg mailing list, send a message with the
  subject: unsubscribe to mrtg-request at list.ee.ethz.ch
* The mailing list archive is at http://www.ee.ethz.ch/~slist/mrtg