[mrtg] Re: Linux CPU Load always zero

[Joey Officer]

I feel like a total idiot.  I did not verify that my two configs were the
same, I took a closer look this morning (with some fresh eyes) and noticed
that I had forgotten about 6 lines off the bottom of my config section,
including the Options[x] line.  I ran the poll once and it actually showed a
value,  I'll let this run for the rest of the day to determine if that was
it.

Thanks Alex..

Joey Officer
<dumbass>

-----Original Message-----
From: Alex van den Bogaerdt <alex at slot.hollandcasino.nl>
To: jofficer at insidehouston.org <jofficer at insidehouston.org>
Cc: MRTG users <mrtg at list.ee.ethz.ch>
Date: Tuesday, September 14, 1999 3:36 AM
Subject: [mrtg] Re: Linux CPU Load always zero


>> all of these number should be right, or fairly close, but my graphs are
>> still returning zero.
>>
>
>Where did your "Options[powerpc.cpu]: gauge" line go ?
>>
>>
Target[powerpc.cpu]:1.3.6.1.4.1.1575.1.5.2.4.0&1.3.6.1.4.1.1575.1.5.2.4.0:pu
>> blic at 192.168.10.200
>> RouterUptime[powerpc.cpu]: public at 192.168.10.200
>> MaxBytes[powerpc.cpu]: 100
>> #AbsMax[powerpc.cpu]: 200
>> #Title[powerpc.cpu]: CPU LOAD
>> PageTop[powerpc.cpu]: <H1>CPU Load %</H1>
>> Title[powerpc.cpu]: CPU Utilization On Prepaid
>> WithPeak[powerpc.cpu]: ymw
>> Unscaled[powerpc.cpu]: ymw
>> ShortLegend[powerpc.cpu]: %
>> XSize[powerpc.cpu]: 380
>> YSize[powerpc.cpu]: 100
>> YLegend[powerpc.cpu]: CPU Utilization
>>
>
>--
>* To unsubscribe from the mrtg mailing list, send a message with the
>  subject: unsubscribe to mrtg-request at list.ee.ethz.ch
>* The mailing list archive is at http://www.ee.ethz.ch/~slist/mrtg

--
* To unsubscribe from the mrtg mailing list, send a message with the
  subject: unsubscribe to mrtg-request at list.ee.ethz.ch
* The mailing list archive is at http://www.ee.ethz.ch/~slist/mrtg