[mrtg] Re: bandwidth statements on Cisco

[Shawn Barnhart]

| Cisco allows bandwidth statements to set the correct clocking speed on the
| serial interfaces. Does this affect the ifSpeed variable?
|
| If it does not, how does the ifSpeed variable get populated with a value?
|

My Cisco command reference for 11.3 says that the bandwidth command is a
reference for higher level protocols. It doesn't say *which* higher level
protocols, but I have a distant memory of a Cisco instructor telling us that
eigrp uses it in route path computation.  I don't think it does anything for
serial interface clocking, the interface command "clock" does this.

You have to use it to populate ifSpeed.


--
* To unsubscribe from the mrtg mailing list, send a message with the
  subject: unsubscribe to mrtg-request at list.ee.ethz.ch
* The mailing list archive is at http://www.ee.ethz.ch/~slist/mrtg