[mrtg] Re: ANNOUCNE 2.9.6

[Angka H. K.]

Is it posible to make MRTG recover the cfg if it's detected the interface
changes on target ?


----- Original Message -----
From: "Tobias Oetiker" <oetiker at ee.ethz.ch>
To: "MRTG Mailinglist" <mrtg at list.ee.ethz.ch>; "MRTG Announcements"
<mrtg-announce at list.ee.ethz.ch>
Sent: Tuesday, December 12, 2000 2:38 PM
Subject: [mrtg] ANNOUCNE 2.9.6


>
> Folks,
>
> Release Fast, Release Often ...
>
> 2.9.6 fixes the ugly bugs introduced in rateup (it is rateup 2.9.4
> again) and finally gets  that *.pid file right which gets created
> when you run mrtg in daemon mode ...
>
> cheers
> tobi
>
>
> --
>  ______    __   _
> /_  __/_  / /  (_) Oetiker, Timelord & SysMgr @ EE-Dept ETH-Zurich
>  / // _ \/ _ \/ / TEL: +41(0)1-6325286  FAX:...1517  ICQ: 10419518
> /_/ \.__/_.__/_/ oetiker at ee.ethz.ch http://ee-staff.ethz.ch/~oetiker
>
>
> --
> Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
> Archive     http://www.ee.ethz.ch/~slist/mrtg
> FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
> WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi
>
>


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi