[mrtg] Re: Scaling on daily graphs

[Stieers, Ken]

There isn't one in 2.x.  You might be able to do something with RRDTOOL, but
I couldn't answer that. 

Ken 
 
> I currently use MRTG to monitor my Cisco 2924M-XL switch that runs our
> core network, and all is well.  However, every night we run backups at
> about midnight local time, and since a lot of data on the 
> servers change
> it normally affects the output quite a bit (about 20x normal 
> output).  Is
> there a way to tell MRTG to say "don't scale until X amount 
> of traffic is
> above a threshhold" that way the nightly backups don't push 
> the scale up
> where my normal data output is almost impossible to read?
> 
> I checked config.html and wasn't sure if there was a way.  
> Anyone know how
> to do this?

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Help        mailto:mrtg-request at list.ee.ethz.ch?subject=help
Archive     http://www.ee.ethz.ch/~slist/mrtg