[mrtg] Re: MRTG graphs

[Tony Bourke]

Hi Vahram,

The graphs, by default, are always set relative to the port in question.
If you have an FE port, and its sending 8megs out and recieving 2 megs in,
it will appear as 8 out and 2 in on your graph.

Hope that helps.

Tony



On Tue, 21 Mar 2000, Keshishian, Vahram wrote:

> Hi everyone,
> 
> I use MRTG to monitor 9 Cisco routers. Everything is fine however I think my
> in and out traffic on the graphs are reversed. 
> 
> I get the same graph whether I monitor the ethernet0 RJ45 interface of the
> router or the Serial1 WIC card of the T1 line.
> 
> Question: Does "in" mean into the router and "out" out of the router,
> regardless of what interface is monitored?
> 
> Thank you,
> 
> 
> 
> Vahram (Victor) Keshishian
> Alameda Corridor Engineering Team (ACET)
> One Civic Plaza, Suite 600
> Carson, Ca. 90745
> Tel (310) 816-0460 x106
> Fax (310) 816-0464
> 
> --
> Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
> Archive     http://www.ee.ethz.ch/~slist/mrtg
> FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
> 

---------------- ------ -- --- -- - - - - -  - ->
Tony Bourke                    tonyb at globalcenter.net
Systems and Architecture Engineer
GlobalCenter, Inc.          917.305.7155

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org