[mrtg] Error.

[*Mick*]

I have been using MRTG to monitor my bandwidth on my Cisco 7206 for a 
while. I recenlty made some changes to the interfaces and Config and 
decided to remap MRTG. When I try to run it, I get the Following error.
PROBLEM: rateup died from Signal 8
  with Exit Value 0 when doing router 'router.xxx.com.24'
  code was 136, retcode was . If this happens all the time,
  you should probably investigate the cause. :-)

Could someone give me a hint?
Mick Loflin	
Support Supervisor/System Engineer
==================================================
Bayou Internet          http://www.bayou.com
Mississippi Internet    http://www.mississippi.net
Vicksburg Online        http://www.vicksburg.com
Bama Online             http://www.bamaonline.net
==============================================


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi