[mrtg] Re: Monitoring ATM ASX1000 switches

[Jason Frisvold]

Here are some OID's you can try :

ATMTRAFFICIN	1.3.6.1.4.1.326.2.2.2.1.2.2.1.12.PORT
ATMFRAFFICOUT	1.3.6.1.4.1.326.2.2.2.1.2.2.1.18.PORT
ATMCPU		1.3.6.1.4.1.326.2.2.1.1.1.3.1.2

You can monitor the ports on the ES-3810 by simply using cfgmaker.

NOTE : The traffic in and out on the ATM switch is measured in cells.  If
you need bytes, multiply this number by 53.

---------------------------
Jason H. Frisvold
Head ATM Engineer
Engineering Dept.
Penteledata
friz at corp.ptd.net
---------------------------
"Only two things are infinite, the universe and human stupidity, and I'm not
sure about the former." - Albert Einstein


-----Original Message-----
From: pierce [mailto:pierce at columbus.rr.com]
Sent: Thursday, September 14, 2000 12:03 PM
To: MRTG
Subject: [mrtg] Monitoring ATM ASX1000 switches



I am a new user of MRTG.  I currently installed version 2.8.9 and I am
trying to monitor all my optical ports on Marconi ATM ASX 1000's switches.

I have found a file called "atmmaker" and it works fine except I only get
information on my pnni links - the single mode links that make up my OC-3
backbone.

I have ES3810's attached to my uni interfaces on these switches but those
interfaces do not show up in MRTG.

Can anyone give me a sample or a tip?

Thanks!

Chris


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi