[mrtg] Re: cpu monitoring...again

[Roth, Gabrielle]

You are trying to use the OID from OLD-CISCO-CPU-MIB.  That is not supported
on the cat switches.  It's been my experience that anything "below"
enterprises.9.5 isn't supported on these switches--usually a good tipoff
you're looking in the wrong place.  Go to
ftp://ftp.cisco.com/pub/mibs/supportlists/wsc6509/wsc6509-supportlist.html
for a list of MIBs supported on 6509s.

I would suggest looking in CISCO-PROCESS-MIB.  You'll find some CPU OIDs
there.  They are different from the OIDs used for routers though (for one,
they are a gauge type as opposed to an integer), so make sure you do your
homework before implementing them.

-gabrielle 

> But no I get a SNMP error,  (I am trying to get CPU from a CAT6509)
> "Received SNMP response with error code
>           error status: noSuchName
>           index 1 (OID: 1.3.6.1.4.1.9.2.1.58.0)"  tried with 
> out the 0 as well
> It appears to be an incorrect MIB value but it matches on the 
> Cisco site.


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi