[mrtg] NT Service shutdowns on MRTG

[Tony Hughes]

Hello Group

I recently moved mrtg-2.9.0pre23 off an NT4 server onto a different NT4 SP6
server and updated to mrtg-2.9.7.  Since then the server application event
log is continuously recording events related to mrtg in groups of 3 as
follows:-
event 1:
The service failed to shutdown correctly due to subprocess being unable to
be killed. Error code: 5. 
event 2:
Subprocess monitoring failed due to subprocess is no longer active. The
subprocess is probably dead. Restarting the process. Error code: 203. 
event 3:
The FireDaemon process was started. 

The sequence of events occurs approximately every 30 seconds and otherwise
MRTG appears to be working as the logs are updating and graphs etc are
working.  I run several config files off a single firedaemon service, and
poll about 250 device interfaces which are a mixture of routers and switch
ports.  It appears to be unrelated to the config as all configs produce the
same results whether run individually or collectively, or as individual
firedaemon services. 
 

Any suggestions would be greatly appreciated.
Regards Tony Hughes


ITD Network Section
Southern Cross University
Lismore NSW Australia
email: thughes at scu.edu.au

Ph (02) 6620 3523
Mobile 0408 110 445
Fax (02) 6620 3033



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi