[mrtg] Cfgmaker hangs on 3662 router

[Kevin Bucknum]

I downloaded and installed mrtg on a linux box yesterday, and started
playing around with it on our network.  I've been able to get it
configured and working on all of the devices in the network but one,
and it's the one I'm most interested in (isn't that always the case).
I'm trying to get info on a 3662.  When I run cfgmaker this is what
happens:


[root at mail1 bucknum]# /usr/local/mrtg-2/bin/cfgmaker --global
'Workdir: /www/lcr
-m.net/mrtg' --global 'Options[_]: bits,growright' --output
/www/lcr-m.net/mrtg/
c3662.cfg lcrm at 10.1.1.1
--base: Get Device Info on lcrm at 10.1.1.1
--base: Vendor Id: cisco
--base: Populating confcache
--base: Get Interface Info
--base: Walking ifIndex
--base: Walking ifType
--base: Walking ifSpeed
--base: Walking ifAdminStatus
--base: Walking ifOperStatus
--base: Walking ifAlias

Then it goes to a sleep status, and just sits there until I end it.
Version info on the 3662:

IOS (tm) 3600 Software (C3660-JS-M), Version 12.1(3a)T1,  RELEASE
SOFTWARE (fc1)

Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled Thu 27-Jul-00 22:43 by ccai
Image text-base: 0x60008960, data-base: 0x61324000

ROM: System Bootstrap, Version 12.0(6r)T, RELEASE SOFTWARE (fc1)

3662_LCR_Main uptime is 2 weeks, 4 days, 17 hours, 15 minutes
System returned to ROM by power-on
System image file is "flash:c3660-js-mz.121-3a.T1"

cisco c3660 (R527x) processor (revision C0) with 121856K/9216K bytes
of memory.
Processor board ID JAB0439C0EN
R527x CPU at 225Mhz, Implementation 40, Rev 10.0, 2048KB L2 Cache
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
Primary Rate ISDN software, Version 1.1.


3660 Chassis type: ENTERPRISE
2 FastEthernet/IEEE 802.3 interface(s)
8 Serial network interface(s)
4 Channelized T1/PRI port(s)
DRAM configuration is 64 bits wide with parity disabled.
125K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

3662_LCR_Main#


I can post the config on the 3662 if need be, but it's very long.  Any
clues what's going on?

Thank you,

Kevin Bucknumm



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi