[mrtg] Antwort: active calls on Cisco3660

[wagner at grz.at]

Perhaps you need to enter the OID ".1.3.6.1.4.1.9.10.19.1.1.5.0".
(additionaly "0")

Regards,
Chris






                                                                    
  An:       <mrtg at list.ee.ethz.ch>                                  
                                                                    
  Kopie:                                                            
                                                                    
                                                                    
                                                                    
  Thema:    [mrtg] active calls on          |---------------------| 
            Cisco3660                       | [ ] Nicht           | 
                                            |     Archivieren     | 
                                            |---------------------| 
 -------+--------------------------------+------------------------- 




Hi, I'm having trouble monitoring active calls on Cisco3660.  I use
.1.3.6.1.4.1.9.10.19.1.1.5 (.cpmPPPCalls), I can see the correct value
with other snmp tools like Getif but when I try it with mrtg strange
things happen:


E:\mrtg\bin>perl mrtg okisdn.cfg
E:\mrtg\bin>perl mrtg okisdn.cfg
SNMP Error:
Received SNMP response with error code  error status: noSuchName  index
1 (OID: 1.3.6.1.2.1.2.2.1.10.5)
SNMPv1_Session (remote host: "192.168.1.1" [192.168.1.1].161)
                  community: "public"
                 request ID: 1898622176
                PDU bufsize: 8000 bytes
                    timeout: 2s
                    retries: 5
                    backoff: 1)
SNMPGET Problem for ifInOctets.5 ifOutOctets.5 sysUptime sysName on
public at 192.168.1.1
WARNING: Expected a number but got
WARNING: Expected a number but got
Rateup WARNING: E:/mrtg/bin\rateup could not read the primary log file
for 192.168.1.1_test
Rateup WARNING: E:/mrtg/bin\rateup The backup log file for
192.168.1.1_test was invalid as well
WARNING: rateup died from Signal 0 with Exit Value 5 when doing router
'192.168.1.1_test'
Signal was 0, Returncode was 5

E:\mrtg\bin>


The config look likes this:

Target[193.4.28.200_test]: .1.3.6.1.4.1.9.10.19.1.1.5:public at 192.168.1.1
MaxBytes[193.4.28.200_test]: 100
Title[193.4.28.200_test]: test
PageTop[193.4.28.200_test]: <h1>test</h1>

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi







--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi