[mrtg] MRTG for constantly changing networks

[Teran, Spencer]

I just started running MRTG and I seem to have a problem.  Right now I am
monitoring close to 200 different routers connected via Frame Relay.  Even
if I add a new sub interface to my core Cisco 7206, I'm having to do some
editing on the mrtg.cfg file so it will see my changes.  My WAN changes
almost everyday, but I don't want to have to sit and configure MRTG every
time I make a slight change on the network (increase bandwidth on a remote
circuit, change IP address, shut down or turn up an interface for a short
amount of time).  Since I am a new user it's quite possible that I am just
not using MRTG to it's full potential.  Is there a trick to getting MRTG's
config file to "update" itself as I add/remove interfaces or change
bandwidth?  Thank you.

Spencer C. Teran
Network Engineer
American Residential Services, L.L.C.
mailto:steran at ars.com



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi