[mrtg] Re: FAQ or How to for rateup to rrd

[Paul C. Williamson]

As Daniel rightfully pointed out....

I had a little trouble getting this after using mrtg - 14all draws the graphs and html on demand, not automatically each time mrtg runs.  Make sure you have the cgi configured correctly.  The reason I did my setup this way was so that I could have 2 separate configs tracking the same data from the same routers, just to make the transition a little easier.  It looked like two totally separate configs to mrtg, one was doing rateup, the other was doing rrd.  Completely seamless transition for my NOC and other areas that use it.  They didn't even know I had switched over until I told them.

Paul

>>> "Daniel J McDonald" <dmcdonald at digicontech.com> 07/13/01 02:31PM >>>
Paul wrote:
>You really only need to add a few lines to the config...
>
>PathAdd: /path/to/rrd/rrdtool-1.0.28/bin/
>LibAdd: /path/to/rrd/rrdtool-1.0.28/perl-shared/
>
>LogFormat: rrdtool
>
>
>What I did was put these three lines into a separate config, and when I was
ready to
>convert the targets in a single config over to rrdtool, I just added an
"Include:
>rrdinfo.cfg" at the top of the config I was converting.  Didn't have to do
anything
>else....MRTG converted everything on the fly, and it worked like a charm...

The other piece of the puzzle is getting 14all.cgi or routers.cgi to work.
That's where he may need help if he's not up on CGI...

Daniel J McDonald, CCIE 2495, CNX
Principal Network Specialist
Digicon Technologies
http://www.digicontech.com 

Digicon, a Cisco Partner, Silver Certified.



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi