[mrtg] OID confusion

[Curtis Bond]

I checked the FAQ but didn't see an answer to this. Can MRTG be used to
graph non-interface items. I need to keep track of a few NetApps F740
and F760. I'd like to check the NFS and RAID info that I've been able to
see from using snmpwalk. I've tried to get cfgmaker to poll these items
but it seems to have problems. It is using ifWalk but these are not if
devices. I'm most likely just not putting the OID numbers in right. I
find the MRTG page covering the Target[]: syntax to be a bit sparse.
What is the significance of the values between the []??

Has anyone else used MRTG to track disk stats via SNMP for a NetApps
device and could you give a newbie a few pointers.

Regards,

Curtis Bond

Sr. Systems Administrator
Network Operations

Wagerworks Inc.
2339 Third St. Fourth Floor
San Francisco, CA 94107

Desk 415.625.8377
Cell   415.748.0571

http://www.wagerworks.com




--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi