[mrtg] Re: OID Cisco Switch 2900 XL

Daniel J McDonald dmcdonald at digicontech.com
Fri Jun 1 17:58:18 MEST 2001


>i want to monitor the traffic for each interface on a Cisco Switch 2900 XL.

If you have a stand-alone switch, just run cfgmaker against it and it will
generate a fine config.

If you have a cluster, you will need to run cfgmaker against it for each
cluster member with a slightly different community string.  If your normal
string were, say "S3cur3", you would run it again with:
S3cur3\@hs1 at commander.ip.address
S3cur3\@hs2 at commander.ip.address
and so forth for each cluster member.


Daniel J McDonald - CCIE 2495, CNX
Principal Network Specialist
Digicon Technologies
http://www.digicontech.com
dmcdonald at digicontech.com

Digicon - A Cisco Systems Partner, Silver Certified.


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi



More information about the mrtg mailing list