[mrtg] Re: [rrd-users] Cammer script

[Shipley, Rob]

When using this script, I noticed the same thing .... if i ran it using the
same device/or 5500 as the switch . ie "cammer community at switch
community at switch(with a rsm)" showed 1/1 then mac. However i was able to get
this to work if you take an actual switch that is on your network and use
the 5500 as the router. For example, use "cammer community at switch(on the
network connected to the 5500) community at router(the 5500)". This worked well
and I got the port/mac address on the switch. In fact we have 2 core 5500's
and when I ran it against the other one, it also gave me the IP Addresses of
the devices connected! This did take longer to run, but that is cool! If you
have any tweaks, etc, let me know.


-----Original Message-----
From: Hewett, Nigel [mailto:Nigel.Hewett at compaq.com]
Sent: Wednesday, June 20, 2001 7:27 AM
To: 'mrtg at list.ee.ethz.ch'; 'rrd-users at list.ee.ethz.ch'
Subject: [rrd-users] Cammer script


Has anyone used this script, as when I run it on a Cisco 5500 Cat it reports
as most PC's connected to 1/1 and not their actual port.
 
Any Ideas
 
Nigel


--
Unsubscribe mailto:rrd-users-request at list.ee.ethz.ch?subject=unsubscribe
Help        mailto:rrd-users-request at list.ee.ethz.ch?subject=help
Archive     http://www.ee.ethz.ch/~slist/rrd-users
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi