[mrtg] curiosity got the better of me...

[Garnel, Eric]

I checked out cammer and ran it against a 2924xl that I am monitoring
already via mrtg and have a few questions...
(some may seem blatantly obvious to others, but not to me at the present)
I am under the impression that it is to be run from the command line (NT)
instead of buried in a config file
	Here is the syntax I am using along with the current output:

	c:\mrtg-2.9.12a\bin>perl cammer.pl public at 192.168.1.5
public at 192.168.1.1
* Gather VLAN index Table from Switch
* Going into Cisco 2900 Mode
* Gather Interface Name Table from Switch
* Gather Arp Table from Router
		* Gather Mac 2 Port and Port 2 Interface table for all VANS

Should it continue after this point? It just seems to sit there....
Should it be directed to an output file ? the script itself and other emails
do not indicate so
What snmp library for Perl is Mike Koch referring to ?  

Also, the router in question is running sub interfaces and hsrp - not sure
that that would make a difference (it doesn't for mrtg)



Eric Garnel
Network Engineer CCNA, MCSE
Question Technologies
Turning Questions into Commerce

701 Brazos Street, Suite 1200
Austin, TX 78701
512/391-4120 direct
512/480-9136 fax
egarnel at question.com
http://www.question.com/ <http://www.question.com/> 



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi