[mrtg] Re: Monitoring 6506 blades

[Kerry Werry]

I monitor a 6509 and just used the standard configmaker to set it up worked
fine....

KLW

-----Original Message-----
From: Robert_Mersberger at BeverlyCorp.com
[mailto:Robert_Mersberger at BeverlyCorp.com] 
Sent: April 16, 2002 1:28 PM
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] Monitoring 6506 blades


I have a 48 port 10/100 blade in my 6506 that I would like to monitor by
port.  I have done a snmpwalk on the 6506 but cannot find the mibs I need to
monitor ports.  The blade is in slot 3 of the 6506 and I would like to
monitor ports 3/1 to 3/6.  
Can anyone tell me how  to do this.  At present I am looking for inocets and
outocets.

I though this would be the same as a 2948G but found it not to be so.

Thanks

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi