[mrtg] SNMP with Cisco 4006

[Jean-Hugues BELPOIS]

Hello,

Still trying to access one of our cisco 4006 catatlyst with mrtg. The
read-only community is sent to public (see below)

c4006-AES> (enable) sh snmp
RMON:                       Disabled
Extended RMON Netflow:      Disabled
Memory usage limit for new RMON entries: 85 percent
Traps Enabled:
Module,Chassis,Bridge,Repeater,Vtp,Auth,ippermit,Vmps,config,entity,stpx,sys
log,system
Port Traps Enabled: None

Community-Access     Community-String
----------------     --------------------
read-only            public


But it's impossible to obtain snmp response from the 4006, when lauchning
cfgmaker with
 cfgmaker --ifref=name --ifdesc=descr --descint --output=/etc/mrtg/4600.cfg
public at 172.30.3.1 (as suggested by Dan, thanks again to him...).

it says :

--base: Get Device Info on public at 172.30.3.1
SNMP Error:
no response received
SNMPv1_Session (remote host: "172.30.3.1" [172.30.3.1].161)
                  community: "public"
                 request ID: 1706335120
                PDU bufsize: 8000 bytes
                    timeout: 2s
                    retries: 5
                    backoff: 1)
SNMPGET Problem for sysDescr sysContact sysName sysLocation sysObjectID on
public at 172.30.3.1

Is anybody see what's wrong ?

thank's

jhb

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi