[mrtg] Re: Just want to know if it is possible

[McDonald, Dan]

If there are a small number of machines, then you could set up CAR and
monitor CAR - quite a pain for normal users, but pretty doable (and
worthwhile) in a colocation environment.

If there are a large number of machines, then your best bet is to use
netflow collection to gather the information you want.  Get information on
flow-tools from www.splintered.net/sw/flow-tools

Daniel J McDonald, CCIE #2495, CNX
Lan/Wan Integrator
Austin Energy
1.512.322.6739
dan.mcdonald at austinenergy.com


-----Original Message-----
From: braveheart at ultra.net.pk [mailto:braveheart at ultra.net.pk]
Sent: Friday, December 27, 2002 6:21 AM
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] Just want to know if it is possible



Hi!

i am running MRTG for a cisco 2600 series router which is acting as a
gateway for my network's traffic to internet. i have configured MRTG to
display the traffic stats of only physical interfaces like eth0 serial0
and serial1. but what i want to do is to gather the traffic stats of all
the machines which are using that router as a gateway. instead of running
MRTG on switch too can i get the desired data from router only. if yes
then how ?

Mahmood Ahmed
ultra.net.pk



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi