[mrtg] Re: Monitoring Serial port traffic on PortMaster 2E30

[Paul C. Williamson]

When you did the snmpwalk, was there a .0 at the end?  I'm betting 
there was.  Try adding a .0 to both OIDs and it will probably start 
working.  To test, just do a

snmpget x.x.x.x community .1.3.6.1.2.1.2.2.1.10.12.0

Paul

>>> "Peter Salvage" <wizard at sybaweb.co.za> 01/10/02 01:24AM >>>

Hi all

I've done an snmpwalk against the portmaster successfully and the following
OID's appear to give me incoming/outgoing octets for the serial port (s10, in
this example):
1.3.6.1.2.1.2.2.1.10.12 (incoming octets)
1.3.6.1.2.1.2.2.1.16.12 (outgoing octets)

However, when I dump this into my mrtg.cfg file as per below, no html output is
generated. Could someone give me a few pointers please?

Target[pm2-pcce]:1.3.6.1.2.1.2.2.1.10.12&1.3.6.1.2.1.2.2.1.16.12:community at ip.ad 
.dr.ess
Title[pm2-pcce]: PCCE Analog
PageTop[pm2-pcce]: <H1>Line Usage </H1>
WithPeak[pm2-pcce]: dwmy
Options[pm2-pcce]: noinfo, growright, gauge
YLegend[pm2-pcce]: PCCE Feed
ShortLegend[pm2-pcce]: PCCE Feed

TIA,
/wiZZ


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe 
Archive     http://www.ee.ethz.ch/~slist/mrtg 
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org 
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi 



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi