[mrtg] Re: temp not working on cisco 7200

[Sawyer, David]

Are you sure you should have 'Options[]: bits' in there?

<Switch on recorded message>

Try adding brackets around the sum to separate the different mathematical
symbols, ie
Target[123]: (OID1&OID2:public at host * 1.8) + 32

<End of recorded message>

HTH
David Sawyer

Email: david.sawyer at mckesson.com

 www.geocities.com/mrtg_daemon
   MRTG/RRDTool daemon for Windows9x/ME/2k
   MRTG GUI ConfigMaker for Windows9x/ME/2k
   TopTalker - See who the top talkers are on your network
   TFTP Cisco configs automagically
   Also tips on how to use mathematical symbols within MRTG


-----Original Message-----
From: MegaNet DomainReg [mailto:domainreg at meganet.net]
Sent: 18 March 2002 16:16
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] temp not working on cisco 7200



Ok i have the following temp config for a cisco, this was working fine
suddenly it stop, now i can only get it to graph 30 degrees F all the time.
I use this config on other ciscos and it still is working fine, any ideas
why it would stop working out of no where.

thanks

Options[_]: bits, growright
Target[frv.cisco.temp]:
1.3.6.1.4.1.9.9.13.1.3.1.3.1&1.3.6.1.4.1.9.9.13.1.3.1.3.1:xxx at x.x.x.x * 1.8
+ 32


----------------------------------------------------------------------------
The information contained in this e-mail is confidential and is intended
only for the named recipient(s). If you are not the intended recipient you
must not copy, distribute, or take any action or reliance on it.
If you have received this e-mail in error, please notify the sender.
Any unauthorised disclosure of the information contained in this e-mail
is strictly prohibited.
----------------------------------------------------------------------------



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi