[mrtg] To low traffic in vlan graph??!! can't make sense.

[Malmgren, Henrik]

Hi all!

When i add all vlan together the sum will be lower than the total output
graph (meashuring on FW). The hardware is cisco catalyst.

Anyone know where the lost traffic goes? Can i measure it?

How can i monitor the REAL amount of traffic on vlans? it's way to low if i
do it like the config below.


ex config:
Target[172.16.1.1_16]: 16:imsetu at 172.16.1.1:
SetEnv[172.16.1.1_16]: MRTG_INT_IP="172.16.1.1" MRTG_INT_DESCR="Vlan202"
MaxBytes[172.16.1.1_16]: 125000000
Title[172.16.1.1_16]: Traffic Analysis for service01
PageTop[172.16.1.1_16]: <H1>Traffic Analysis for service01</H1>
<TABLE>
<TR><TD>System:</TD> <TD>service01 </TD></TR>
<TR><TD>Maintainer:</TD> <TD></TD></TR>
<TR><TD>Description:</TD><TD>Vlan202 ACL 2302-2303, service01 </TD></TR>
<TR><TD>ifType:</TD> <TD>propVirtual (53)</TD></TR>
<TR><TD>ifName:</TD> <TD>Vl202</TD></TR>
<TR><TD>Max Speed:</TD> <TD>125.0 MBytes/s</TD></TR>
<TR><TD>Ip:</TD> <TD>172.16.1.1 ()</TD></TR>
</TABLE>
 


Henrik Malmgren 

---------------------------------------------
This E-mail is Virus scanned by Mail Marshal.
Postmaster at ims.se
---------------------------------------------

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi