[mrtg] Re: Cisco Router IOS

[Varosky, Geoff]

It is possible that if you were graphing just using the ifIndex number, that
it could have changed. A router will usually do this after a reboot if new
interfaces have been added. You may want to try using the --ifref=descr
switch when running cfgmaker, and work off the interface name instead of the
ifIndex #, that way, when you reboot, you'll still be able to graph fine.

Hope this helps!

Regards, 
Geoff Varosky 
Network Engineer
Systems Administrator
REON Broadband
phone:  508-787-3434 ext. 1529
email:  geoff.varosky at reonbroadband.com
-------------------------------------------------
For Technical Support, Please Call 1-866-REON-HLP
or Email Support at support at reonbroadband.com.
Or visit our Support website for more information, 
network, and maintenance announcements at:
http://www.reonbroadband.com/support.shtml
-------------------------------------------------


-----Original Message-----
From: Chapman, Matt [mailto:chapmam2 at ocps.k12.fl.us]
Sent: Wednesday, May 15, 2002 11:39 AM
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] Cisco Router IOS



Hi all,

I have noticed that if I upgrade the IOS on my Cisco router that MRTG
stops being able to graph it.  Is this normal.  I have been removing the
router from my conf file and re cfgmaker the router to get it going
again.  Anyone else notice this???

-matt chapman

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi