[mrtg] Re: CONFIG CISCO SWITCH 5000

[Bill Carter]

At the switch do a show ifindex 123

-----Original Message-----
From: mrtg-bounce at list.ee.ethz.ch [mailto:mrtg-bounce at list.ee.ethz.ch]On
Behalf Of Justin Shore
Sent: Wednesday, May 15, 2002 11:40 AM
To: Mahesh Basantani; 'mrtg at list.ee.ethz.ch'
Subject: [mrtg] Re: CONFIG CISCO SWITCH 5000



At 11:00 AM +0200 5/15/02, Mahesh Basantani wrote:
>Hi ,
>I have generated a config file for a CISCO SWITCH .Please can anyone guide
>How do I correspond relevant ports to the config file .
>Thanks
>Mibsun

I typically SNMP walk the device to figure out which port # 
corresponds to which physical (or virual) port.  It works pretty well 
for me.

Justin
-- 

--
Justin Shore, ES-SS ES-SSR      Pittsburg State University
Network & Systems Manager       Kelce 157Q
Office of Information Systems   Pittsburg, KS 66762
Voice: (620) 235-4606           Fax: (620) 235-4545
http://www.pittstate.edu/ois/

Warning:  This message has been quadruple Rot13'ed for your protection.

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi