[mrtg] Re: SNMP Loop when scanning Cisco 6509 Sup1

[Gonzalez, Jorge H.]

Hi, if you are using the CatOS, the command to know the Interface instance
is show ports, at the end of the output is the ifindex for each port in the
Catalyst.

Jorge Hto Gonzalez



-----Mensaje original-----
De: Alex van den Bogaerdt [mailto:alex at ergens.op.het.net]
Enviado el: Miércoles, 16 de Octubre de 2002 06:18 p.m.
Para: 'mrtg at list.ee.ethz.ch'
Asunto: [mrtg] Re: SNMP Loop when scanning Cisco 6509 Sup1



On Wed, Oct 16, 2002 at 06:48:16PM -0400, Toepp, Tim wrote:

> So I ran the SNMPWalk command on it and found out that when it gets to the
> following line it will start looping:
> Interfaces.ifTable.ifEntry.ifIndex.88=88

> I'm running 2.9.18, and I've been able to get other Cisco routers and
> switches, but didn't know if anyone had the same problem when gathering
> information from the 6509 Sup1.  Or if someone knows why I'm getting this,
> how to fix it or how to setup a work around...

Work around:
Do not use cfgmaker.  You do not *need* it to produce a working config file,
it is just very handy.  Interface instances can be queried from the switch
command line ("show interface detail" or something alike, search the
archives)

The solution is probably to up- or downgrade the switch software but I don't
know for sure.  Maybe Cisco knows, visit the TAC.

HTH
Alex

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi