[mrtg] Re: cfgmaker & frame-relay interfaces only

[Brander, Eric]

Wouldn't it be easier to just remove the lines in the config that you don't
want to monitor?  Besides, I don't know how you can ask ConfigMaker to check
to see if an interface is frame relay.  I guess you could poll an SNMP OID
for description and then look for "Frame" or something... but that would
mean that the descriptions would have to have "Frame" in them.  Still... a
lot easier to just clean up the config file after its been made, I think.

 -----Original Message-----
From: 	Gibson, Paul [mailto:paul.gibson at atosorigin.com] 
Sent:	Monday, September 09, 2002 11:10 PM
To:	mrtg at list.ee.ethz.ch
Subject:	[mrtg] cfgmaker & frame-relay interfaces only


Hello,


	Id it possible to get cfgmaker to generate a cfg file for a router
but ONLY grab the frame relay interfaces ???

there are no options that I can see for this,  and my perl isnt sufficient
to modify the cfgmaker code

 Regards
 
 Paul Gibson
 

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi