[mrtg] Re: Logging / Graphing Issues

[Peter Glanville]

>The log file looks somewhat as follows:
>1050011711  227  227
>1050011711  0 0 0 0
>1050011112  0 0 0 0

Are you using the Guage option?
You have read in low values (227 for both variable being plotted). 5 mins
later MRTG re-runs, and (by default) takes the previous value from the
current value, and divides by 300 to get the 'per second' rate. Fractions
are not stored.
Values above Maxbytes (or AbsMax, if defined) are also dropped.

Using 'Gauge' cause the system to not divide by 300, but simply plot the
value (good for UPS voltage, current, etc)

For systems with very low rates of change (eg printer pages are normally
less than one per second), you can use options like PerMinute etc.

Without knowing what you are plotting, and what entries are in your log
file, it is impossible to be more specific.

The time value is seconds since the beginning of time, the first two colums
are the average/gauge values for the time interval and will be plotted in
the graph, the last two are the peak rates (in case you use the withpeak
option)

Regards
Peter




--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi