[mrtg] Re: SNMP Problems after installing a WIC in 2620

[Michael Markstaller]

Which IOS is this box running and which WIC have you inserted ?
Have you configured "snmp-server ifindex persist" ? maybe just the ifref changed..

Michael

-----Original Message-----
From: mrtg-bounce at list.ee.ethz.ch [mailto:mrtg-bounce at list.ee.ethz.ch]On
Behalf Of Nate McLain
Sent: Monday, December 15, 2003 1:18 AM
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] SNMP Problems after installing a WIC in 2620


Hello List!

I had SNMP working on my 2620.
The unit only had 2 ethernet interfaces in it which connected to my fiber
transceiver. I had MRTG working just fine. And I also use STG traffic
grapher to check my router as well.
After I installed the WIC in the 2620 I am no longer able to get data via
SNMP. I have checked the Cisco config and made sure that snmp was still
enabled and it is. So I shut the router down, removed the WIC and rebooted
the router. And then SNMP was working again.

Has anyone seen this problem before?

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi