[mrtg] Re: PIX-515E CPU/Connection woes

[Bill Parker]

At 08:11 AM 2/25/2003 -0800, you wrote:

>I had the same results - I am told I need to upgrade my IOS to 6.2(2) as the
>version I am running - 6.0(3) does not support the process MIB which is
>where all the CPU stats reside.

Well, I am running 6.2(2)

this is what a 'sh ver' returns:

Cisco PIX Firewall Version 6.2(2)
Cisco PIX Device Manager Version 1.1(2)

Compiled on Fri 07-Jun-02 17:49 by morlee

DonBest-pix up 7 days 7 hours

Hardware:   PIX-515E, 64 MB RAM, CPU Pentium II 433 MHz
Flash E28F128J3 @ 0x300, 16MB
BIOS Flash AM29F400B @ 0xfffd8000, 32KB

Encryption hardware device : IRE2141 with 2048KB, HW:1.0, CGXROM:1.9, FW:6.5
0: ethernet0: address is 0009.b7f7.68c0, irq 10
1: ethernet1: address is 0009.b7f7.68c1, irq 11
2: ethernet2: address is 00e0.b606.993b, irq 11
3: ethernet3: address is 00e0.b606.993a, irq 10
4: ethernet4: address is 00e0.b606.9939, irq 9
5: ethernet5: address is 00e0.b606.9938, irq 5
Licensed Features:
Failover:           Enabled
VPN-DES:            Enabled
VPN-3DES:           Disabled
Maximum Interfaces: 6
Cut-through Proxy:  Enabled
Guards:             Enabled
URL-filtering:      Enabled
Inside Hosts:       Unlimited
Throughput:         Unlimited
IKE peers:          Unlimited

Serial Number: 806272648 (0x300ebe88)
Running Activation Key: 0xf690c830 0xb48c361d 0x863c3547 0x842d13b3
Configuration last modified by enable_15 at 07:38:09.115 UTC Fri Jan 8 1993
pix# sh cpu
Usage:  show cpu usage
pix# sh cpu usage
CPU utilization for 5 seconds = 0%; 1 minute: 0%; 5 minutes: 0%

When I do a 'sh conn' I get this

pix# sh conn
894 in use, 1881 most used

So the PIX is able to store this information somewhere, I just can't seem 
to get at it

GRRRRR :)

-Bill

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi