[mrtg] Config Maker

[Crow Lee Contr 379 ECS]

Content-Type: text/plain

Ok... I have been reading up on MRTG for a while.  I am having a couple of
issues with it, but I'll just address one here for now.  This problem may be
obvious to everyone else, but for some reason I am just not getting it.
 
Let's say I have a Cisco 6513 switch with the following parameters.
 
IP: 192.168.1.1
RO Community String: grooving
 
Everyone here probably knows well and good that when I run config maker it
will only give me the configs for interface in/out info.  What if I wanted
to monitor a different OID?  Can I use config maker with an output variable
to do this or do I just have to know how to write the config?
 
Say I want to monitor the following OID (Just grabbing one as an example):
 

CISCO-SMI 
1.3.6.1.4.1.9.9.109.1.2.1.1.2.9.9 
ciscoMgmt.109.1.2.1.1.2.9.9 
TempMon 
 
Can someone please help?  What I am actually trying to do is monitor air
intake temperature.  We are in a very hot environment, the Middle East, and
this temp. would represent our ITN ambient temperature so that we can keep
our equipment from overheating.
 
Thanks for the help!
 
 



 Lee Crow
 Senior LAN/WAN Administrator
 ITT Systems 
  _____  

 

 DSN: 471-2074
 Cell: +974-556-3127
  <mailto:Lee.Crow at auab.aorcentaf.af.mil> Lee.Crow at auab.aorcentaf.af.mil
 
 



-- Attached file removed by Ecartis and put at URL below --
-- Type: image/gif
-- Size: 2k (2156 bytes)
-- URL : http://www.ee.ethz.ch/~slist/pantomime/27-image001.gif


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi