[mrtg] Re: Alteons -- Speed set to 0?

[Greg.Volk at edwardjones.com]

Assuming these are 10/100 ethernet ports there is usually
a device configuration setting to lock the speed per port. 
I would suggest locking the speed (and duplex for that 
matter) and see if that results in a config file with real 
maximums.


}-----Original Message-----
}From: Aaron.Conaway [mailto:Aaron.Conaway at HOSystems.com]
}Sent: Thursday, January 30, 2003 1:58 PM
}To: mrtg
}Subject: [mrtg] Alteons -- Speed set to 0?
}
}
}
}I have a pair of Alteons doing load balancing of our web 
}servers that I could like to monitor with MRTG; however, when 
}I run cfgmaker against them, all the interfaces are commented 
}out with reason "has a speed of 0 which makes no sense."  
}Since all the interfaces are commented out, it does me very 
}little good to see an empty web page.  :-)
}
}Has anyone seen this issue?  How can I get around this?  Any thoughts?
}
}I found a few messages in the archive that pertain to this, 
}but, when I click them, it takes me to a different thread.  
}Please forgive the ignorance.
}
}Thanks...
}
}Aaron Conaway
}Network Engineer III
}Verisign TSD
}Phone:  912.527.4343
}
}--
}Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
}Archive     http://www.ee.ethz.ch/~slist/mrtg
}FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
}WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi
}
}


-- Attached file removed by Ecartis and put at URL below --
-- Type: application/ms-tnef
-- Size: 2k (2206 bytes)
-- URL : http://www.ee.ethz.ch/~slist/pantomime/39-WINMAIL.DAT


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi