[mrtg] Monitoring Error Packet
KAJI,KOTARO (HP-Japan,ex2)
kotaro.kaji at hp.com
Wed Jun 4 03:20:07 MEST 2003
I had measured the error packet of a WAN circuit
by the following CONFIG on the VLAN interface
of MSFC (Catalyst6500).
-----ERROR IN--------
#ifInErrors(14) & ifInUcastPkts(11) +
#Dummy & ifInNUcastPkts(12) +
#Dummy & ifInDiscards(13) +
#Dummy & ifInErrors(14) +
#Dummy & ifInUnknownProtos(15)
Target[target_name]: ( .1.3.6.1.2.1.2.2.1.14.interface_num&.1.3.6.1.2.1.2.2.
1.11.interface_num:community_name\@host_name +
.1.3.6.1.2.1.15.2.0&.1.3.6.1.2.1.2.2.1.12.interface_num:community_name\@host
_name +
.1.3.6.1.2.1.15.2.0&.1.3.6.1.2.1.2.2.1.13.interface_num:community_name\@host
_name +
.1.3.6.1.2.1.15.2.0&.1.3.6.1.2.1.2.2.1.14.interface_num:community_name\@host
_name +
.1.3.6.1.2.1.15.2.0&.1.3.6.1.2.1.2.2.1.15.interface_num:community_name\@host
_name ) * 300
-----ERROR OUT--------
#ifOutErrors(20) & ifOutUcastPkts(17) +
#Dummy & ifOutNUcastPkts(18) +
#Dummy & ifOutDiscards(19) +
Target[target_name]: ( .1.3.6.1.2.1.2.2.1.20.interface_num&.1.3.6.1.2.1.2.2.
1.17.interface_num:community_name\@host_name +
.1.3.6.1.2.1.15.2.0&.1.3.6.1.2.1.2.2.1.18.interface_num:community_name\@host
_name +
.1.3.6.1.2.1.15.2.0&.1.3.6.1.2.1.2.2.1.19.interface_num:community_name\@host
_name ) * 300
-------------
However, by this method, it turns out that it cannot
measure and changed to measurement in the physical
port of Catalyst6500.
All that matters here is that OID (.1.3.6.1.2.1.15.2.0)
of Dummy does not exist in Catalyst6500. OID which
always returns 0 is known?
(.1.3.6.1.2.1.15.2.0=bgpLocalAs)
Is there any method using OID of Dummy?
Thanks
/K Kaji
--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive http://www.ee.ethz.ch/~slist/mrtg
FAQ http://faq.mrtg.org Homepage http://www.mrtg.org
WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
More information about the mrtg
mailing list