[mrtg] Re: PM3 MRTG Graph incorrect

[Pete Templin]

It has been a LONG time since I set up MRTG on a PM3, but the common OID that people monitor is the number of interfaces.  The Ethernet interface always counts as one, so you'll need to subtract one from the gathered number.

Pete Templin
IP Network Engineer
TexLink Communications
(210) 892-4183
pete.templin at texlink.com

-----Original Message-----
From: Mrtg [mailto:mrtg at gowebco.com]
Sent: Friday, March 07, 2003 3:56 PM
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] PM3 MRTG Graph incorrect

Hi all,

        Quick question.  Probably pretty dumb, but here goes....

        I've got a few PM3's that I graph modem usage on..  I am using
1.3.6.1.2.1.2.1.0&1.3.6.1.2.1.2.1.0:whatever-community at xxx.xxx.xxx.xxx:
for the OID.  The graphs come out, but ALWAYS 1 higher than what is in
use.  I can actually graph a PM3 with no one on it, and it will show 1
modem in use.  I believe I have delt with this before, but it has been
quite awhile since I have graphed PM3's.  Any ideas?

Thanks,

-Ronan


Ronan Eckelberry
Sr. Network/Systems Engineer
WEBco Solutions, Inc
(352)746-2500
www.webcosolutions.com


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi