[mrtg] traffic above MaxBytes graphed incorrectly

[A. Schirmacher]

I have a low traffic server with occasional peaks
during backup time (several MByte/sec). If I use the
default cfg settings then everything is scaled so that
the peaks fit in, but the rest is unrecognizable.

This cfg file below is close to what I want but during
backup time the graph is stuck at the last setting. I
want it at the max setting (100 KByte/sec), but I
could not figure out how to do this.

Any suggestions?

Here's the cfg file:

Target[net2]: 2:public at p15096863.pureserver.info
WithPeak[net2]: ymwd
MaxBytes[net2]: 100000
Unscaled[net2]: ymwd
RouterUptime[net2]: public at p15096863.pureserver.info
Options[net2]: growright
Title[net2]: Traffic Analysis
PageTop[net2]: <H1>Network Traffic Analysis for
eth0</H1>


__________________________________________________________________

Gesendet von Yahoo! Mail - http://mail.yahoo.de
Bis zu 100 MB Speicher bei http://premiummail.yahoo.de

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi