[mrtg] Re: Different hosts/router in one config file

[Aaron Conaway]

I asked this question a few weeks ago.  It should be in the archives.

You can use a master config file and use many includes.  You can also
use full paths to include, allowing you to have a directory structure
for your config (like a dir for a client, or a dir for device types,
etc.).  These points are very helpful when it comes to using
"third-party" CGI, like 14all.cgi and routers2.cgi.

----------
Aaron Conaway
Network Engineer III
Verisign, Inc. -- Telecom Services Division
http://www.verisign.com
Office:  912.527.4343
Fax:  912.527.4014


-----Original Message-----
From: AS, Raj Kumar [mailto:RajKumar at solectron.com] 
Sent: Monday, March 31, 2003 2:36 AM
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] Different hosts/router in one config file


Dear Group,
I am running MRTG 2.9.21 on a WIN2k server. Is it possible to have a
separate .cfg file for each host/router, and add it to a master .cfg
file and run mrtg. The reason I ask this is because quite often I need
to add new hosts/router to monitor. Just thinking of a easier way to do
this rather than re-running the one config file again and again.

Appreciate your thoughts and suggestions. Thanks.

Best Regards,
Raj.



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi