[mrtg] Re: Disk Utilization For WinNT

[wolfe at daticon.com]

I have tried this. When I look at the OID list using snmpwalk, I only see
the same ones that were there before I installed snmp4tpc. I even set up a
new WinNT 4.0 server so I could do this from scratch. No go. I followed the
instructions on the site and checked the troubleshooting page. Any ideas?

Austin Wolfe

-----Original Message-----
From: fluhmann at vvm.com [mailto:fluhmann at vvm.com]
Sent: Thursday, May 22, 2003 4:06 PM
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] Re: Disk Utilization For WinNT


Try looking at http://www.snmp4tpc.com/  and click on SNMP4NT.  It will
install the MIB's for you to be able to monitor performance on NT.

Hope that helps,
Jeremy Fluhmann
McLane Information Systems Division


wolfe at daticon.com wrote:

>Hello Group,
>	I look ed at the Somix WinNT disk utilization MRTG config but my
>WinNT 4.0 server does not seem to have the OIDs. I have done an SNMPwalk
and
>did not find them. Has anyone here set up MRTG to monitor disk utilization
>of a WinNT 4.0 box? If so, how did you do it?
>
>Thank,
>Austin Wolfe
>



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi