[mrtg] High bandwidth interface problems over 100Mbps

Michael P. Handley handley at lightspeedtech.net
Mon May 26 23:32:15 MEST 2003

> Hi,
>   I have a switch that is pushing over 150Mbps on a Gig interface.  I am using snmpv2c to monitor the interface (on a cisco catalyst switch) and once the average gets above about 110Mbps, mrtg reports the bandwidth as 15-20Mbps!  I can verify from the switch that this is incorrect, but I can't figure out how to get around it.  
> Using v2c, I shouldn't have an issue with the counters resetting?   Has anyone run into this before? 
> Thanks
> Mike

Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

More information about the mrtg mailing list