[mrtg] Re: Finding OID for particular command.

Zeeshan Ahmed zeeshan at worldcall.net.pk
Wed Oct 15 02:02:11 MEST 2003


Can you ply guide me how I can use these MIBs

Regards
Zeeshan Ahmed

-----Original Message-----
From: mrtg-bounce at list.ee.ethz.ch [mailto:mrtg-bounce at list.ee.ethz.ch] On
Behalf Of Daniel J McDonald
Sent: Tuesday, October 14, 2003 4:46 AM
To: Zeeshan Ahmed
Cc: MRTG Mailinglist
Subject: [mrtg] Re: Finding OID for particular command.

On Tue, 2003-10-14 at 12:54, Zeeshan Ahmed wrote:
> Dear All
>         How can i get OID against a particular command of router.Like i
want to graph diferent aspect of a Cisco 7200 Router Commands.Like i want to
monitor the output of this command
> router#sh ip nbar resources

I don't have an NBAR configured router readily at hand, but you might
check cnpdAllStatsTable in the CISCO-NBAR-PROTOCOL-DISCOVERY-MIB

-- 
Daniel J McDonald, CCIE 2495, CNX
Austin Energy


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi




--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi



More information about the mrtg mailing list