[mrtg] Re: Y axis values from 0.0 to 0.0 ?!?!?

[Koelstra, J. (Jan)]

Alec,

Do you realize MRTG shows only whole numbers? 
By using "Factor[xxx]: 0.01" a value of 99 is changed to 0.99 which is
rounded down to 0

Hth,

Jan.
-----Original Message-----
From: Alec Waters [mailto:alec.waters at dataline.co.uk] 
Sent: Thursday, October 30, 2003 12:57 PM
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] Re: Y axis values from 0.0 to 0.0 ?!?!?


Alec Waters wrote:
> I'm having an intermittent problem with MRTG 2.10.5, which I'm using 
> to > draw graphs of wind speed. The values I get back from the wind
sensor
> are integer centimetres per second - I want to display these on the 
> I use Factor[xxx]: 0.01 and YTicsFactor[xxx]: 0.01.

Forgot to say:

Removing YTicsFactor causes the graphs to draw properly again, but of 
course displaying cm/s instead of the desired m/s. Is there a bug with 
YTicsFactor? Or am I misunderstanding something?

thanks a lot,
alec
-- 
Alec Waters
Dataline Software Ltd
Clarence House, 30-31 North Street, Brighton, BN1 1EB, UK

Tel: +44 (0)1273 324939
Fax: +44 (0)1273 205576
www: http://www.dataline.co.uk
IPv6: http://www.ipv6.dataline.co.uk


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi



Het ministerie van Sociale Zaken en Werkgelegenheid sluit elke aansprakelijkheid uit in verband met het niet juist, onvolledig of niet tijdig overkomen van de informatie in deze e-mail. 
Aan dit bericht kunnen geen rechten worden ontleend. 

Dit bericht is alleen bestemd voor de geadresseerde. Indien dit bericht niet voor u bestemd is, verzoeken wij u dit onmiddellijk aan ons te melden en de inhoud van het bericht te vernietigen. 
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
The ministry of Social Affairs and Employment is not liable for any incorrect or incomplete transmission of the information in this e-mail or for any delay in its receipt. 
This message shall not constitute any obligations.

This message is intended solely for the addressee.
If you have received this message in error, please inform us immediately and delete its content.

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi