[mrtg] Re: Error when configuring mrtg

[Luis]

You must watch the configuration in your router. May be SNMP server is
not enable in the router. You can configure it by typing snmp-server
community YOUR-COMMUNITY in the configure terminal prompt.

Good luck.

-----Mensaje original-----
De: mrtg-bounce at list.ee.ethz.ch [mailto:mrtg-bounce at list.ee.ethz.ch] En
nombre de Eduardo Sanchez
Enviado el: jueves, 18 de septiembre de 2003 16:45
Para: mrtg at list.ee.ethz.ch
Asunto: [mrtg] Re: Error when configuring mrtg


> -----Original Message-----
> From: Luis [mailto:luis.cano at eresmas.com]
> Sent: Thursday, September 18, 2003 8:31 AM
> To: Eduardo Sanchez; mrtg at list.ee.ethz.ch
> Subject: [mrtg] Re: Error when configuring mrtg
> 
> 
> It seems your router is not responding SNMP querys.. Any FW,
> bad community, access-list, wrong IP address...? Try 

Probably my community string is bad, I put 'public at ip_address', the
router is a CISCO 2600, it uses another community string different from
the standard one??
Regards,	

  -eduardo s.m.

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi