[mrtg] Incorrect Trunking Graphs

[wolfe at daticon.com]

Hello Group,
	I use MRTG to monitor all of my Cisco switches and routers. I did
some changes in the network and I reconfigured MRTG. I have all of my
switches trunked and on one of my 4006 switches the MRTG graph shows trafic
on both trunks. This should not occur since port 1/1 is set for blocking and
port 1/2 is set for forwarding. The amount of traffic can reach 32MB on port
1/1 which is showing as being in a blocking state. I have been checking the
trunks and they have not switched and if they did, I would notice it since I
would get calls from users that are on that switch. I took a look at the
MRTG List archive and did not find anything that helps. Has anyone else seen
this?
	I am using MRTG on a Linux slackware server. 

Thanks,
Austin Wolfe

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi