[mrtg] Re: where to place OID

[Jon Nistor]

If you're monitoring CRC errors you wont need to specify the interface at
the front.  The OID should match up to the interface (based on ifIndex
most likely.)  So if your ifIndex for atm0/0/0 is 23 it will most likely
look like:

1.3.6.1.4.1.9.2.2.1.1.12.23
                         ^----- ifIndex of port.

so it would look like:
Target[target]:  oid&oid:community at device

Hope this helps...

||Hi All,
||I'm trying to monitor CRC errors on my main Internet router's ATM interface and also on the Gig interface.
||If my target for the ATM =
||[TARGET]: \ATM0/0/0:communityname at myrouter:
||where do I place the OID's?  Between or before the forward slash or after the forward slash?
||So it would read as follows:
||[TARGET]: \ATM0/0/0: 1.3.6.1.4.1.9.2.2.1.1.12.1&1.3.6.1.4.1.9.2.2.1.1.12.1:communityname at myrouter:
||
||My target for my Gige =
||[TARGET]: \GigabitEthernet2/0/0:communityname at myrouter:
||So it would read as follows:
||[TARGET]: \GigabitEthernet2/0/0: 1.3.6.1.4.1.9.2.2.1.1.12.1&1.3.6.1.4.1.9.2.2.1.1.12.1:communityname at myrouter:
||
||Have I misplace the OID and/or am I using too many colons?
||Please help...I feel as if I'm sinking, again!
||
||
||-Patricia
||
||--
||Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
||Archive     http://www.ee.ethz.ch/~slist/mrtg
||FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
||WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi
||

 ________
  Jon (nistor at snickers.org) - iooooio.iioooiii.ioiioioo.iiiiioio

: EOF
:

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi