[mrtg] Re: MRTG to measure call volumes

[Barber, Erik A.]

Here's the config I use to monitor our 5300's, it may be the same...

Target[as5300-1]: 1.3.6.1.4.1.9.10.19.1.1.4.0&1.3.6.1.4.1.9.10.19.1.1.4.0:snmpstring at as5300 
YLegend[as5300-1]:Primary AS5300
ShortLegend[as5300-1]: users
MaxBytes[as5300-1]: 96
Unscaled[as5300-1]: dwmy
Options[as5300-1]: gauge, unknaszero, growright
Title[as5300-1]: Primary AS5300 Users
PageTop[as5300-1]: <H1><b>Primary AS5300 Active Users (888 Toll Free Lines)</H1>
Legend1[as5300-1]: Active User Connections
Legend2[as5300-1]:
Legend3[as5300-1]: Max value per interval on graph
Legend4[as5300-1]:
LegendI[as5300-1]: Users
LegendO[as5300-1]:
 

-----Original Message-----
From: mrtg-bounce at list.ee.ethz.ch [mailto:mrtg-bounce at list.ee.ethz.ch] On Behalf Of Bryan Decker
Sent: Wednesday, May 05, 2004 11:42 AM
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] MRTG to measure call volumes

I am trying to use MRTG to graph out some information for our dial-up gear. I have the correct OIDs (finally), but I'm not getting any data in my graphs. We have a Cisco AS5800 running IOS 12.2-16(a). The OIDs I'm looking at are:
1.3.6.1.4.1.9.9.47.1.1.7.0
1.3.6.1.4.1.9.9.47.1.1.6.0

The SNMP settings on the gear are correct, I believe. There are no errors on the cron-tab, and the graph page says it's updated. Any ideas on what I've done wrong?

Thanks
Bryan
Bryan Decker
Network and IP Engineer
Smithville Telephone Company

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi