[mrtg] Re: Cisco Pix monitor

[Stefano Giraldo]

Hi,
on my Cisco PIX 520 with 6.3(1) PIX Software, I did
cfgmaker --global 'WorkDir: /var/www/mrtg' --ifref=name
community at outside_pix_interface:::::2
(obviously on Linux) and it worked fine.
So, the error it's enough eloquent, it seems you have two interfaces with
the same name.
Hope my suggestions will useful.

Bye,

        Ste.

----- Original Message ----- 
From: "Paul Hong" <phong at mbcsystems.org>
To: <mrtg at list.ee.ethz.ch>
Sent: Tuesday, November 02, 2004 8:02 PM
Subject: [mrtg] Cisco Pix monitor


> Hi all.
> I got my snmp for cisco pix setup, but when I run updatemyrouter.bat.
>
> I get this .cfg file.
>
>
>
> ### Interface 1 >> Descr: 'PIX-Firewall-'outside'-interface' | Name: '' |
> Ip: '207.215.60.67' | Eth: '00-50-54-ff-34-12' ###
>
> ### The following interface is commented out because:
>
> ### * --ifref=name is not unique for this interface
>
>
>
> Any response would be greatly appreciated.
>
>
>
> Paul Hong
>
>
>
> --
> Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
> Archive     http://www.ee.ethz.ch/~slist/mrtg
> FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
> WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi
>
>

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi