[mrtg] Re: MRTG Mapping Fractional T1

[Andrew Hull]

Are you talking about a channelized T1 like a bank of PRIs or DS0s for a 
dial up bank or a full T1 circuit that is not "turned up" all the way?

The latter should be the same a monitoring a full 24 channel T1, just 
adjust MaxBytes to match your throughput.

If configured properly, the former will be just as easy. Each channel 
will be its own interface in the rotuer/access server, and the config 
maker tool will detect them all.

Basically, do a "show interface" on your (cisco) router, each interface 
listed is individually monitorable.

Andrew

Natalie Aloi wrote:
> Does anyone know of a way to map individual channels from a t1 through
> MRTG?
> 
> CONFIDENTIALITY NOTICE: This message and any attached documents may contain confidential information from Synergy One FCU.
> 
> 
> 
> --
> Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
> Archive     http://lists.ee.ethz.ch/mrtg
> FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
> WebAdmin    http://lists.ee.ethz.ch/lsg2.cgi
> 
> 

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://lists.ee.ethz.ch/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://lists.ee.ethz.ch/lsg2.cgi